Hi Guys
What are the tricks to make rotating the newtonian OTA within the tube rings during an observing session an easy operation?
I seem to have so much difficulty rotating the OTA even with the tube clamps loosened.
Is there any method to make this a less frictionless manouvere?
Thanks Guys

_________________
Meade LX 10 8" SCT OTA, HEQ5,
Celestron X-cel LX 7mm,9mm,12mm,18mm,25mm
Skywatcher Panaview 32mm
Revelation 2" 42mm
William Optics Binoviewer
William Optics SCT Crayford Focuser
Olympus 8X40 DPS I binoculars

That is all you can do

_________________
Celestron 8" Edge HD Evolution, Esprit 120mm triplet, 72mm APO, Sky Tee 2, 6" reflecting scope, William Optics Binoviewer, Quark Daystar Ha Chromosphere on 72mm ED, LVW8mm eyepiece and Celestron 19mm Axiom, matched W.O 10 and 20mm, and a few others, D4s, D810,

For info, I am Autistic, Aspergers, ADHD, therefore if I come over as a little "short" on occasions it is not intended, thank you

It helps if handles are attached to the 'scope to pull it round into position.

_________________
brian